Networking Development

First of all we had to use the software using PACKET TRACER

When we logged into the packet tracer we had to make a scenario of four routers and four switches and computers to make a design and make sure that they are connected and the messages can be sent to different routers and anyone in the system can access files from different location and files.

1. First you go to start > networking > packet tracer

2. When you have clicked on the program and wait for it to load and once the program has uploaded it should be up and ready to use.

3. Then you start using the tools to create your scenario

4. Then you decide what tool to use and where and how to connect them altogether then you have to program them together.

5. Then you click on the computer icon on the implementation and an icon should come up then u click on top of the tab desktop and then click on the IP configuration

6. When clicked you click on the radio button saying "DHCP" and it should say if it working

7. It would come on up as DHCP request failed then you know it's not configured. If not then u exits the icon.

8. Click on the router and a different box comes up and on the top tab you click on the tab "CLI", this is where you enter the code

9. I am going to be using the DHCP to make my scenario work. Then we start configuring the DHCP

10. I started with entering the code.( As shown below)

This part of the code will be already on the system before you start entering any code you need to type in.